Our policy requires our home to be inspected, which was done months ago (September), I wasn't expecting it, but not surprising.
Here's how Google AI guides me on handling the requirement of the inspection result:
To satisfy your NJM Insurance Group underwriting notice before the December 10, 2026 deadline, you need to address four specific exterior maintenance items. Because you have roughly three weeks left and temperatures in South Amboy are dropping, prioritize the painting and mortar work immediately while daytime highs are still above 40°F–50°F. [1]
1. Repair the Rotting Shed Fascia & Paint the Shed
Looking at your third photo (the close-up of the shed gable), the angled rake trim boards along the roofline show heavy moisture staining, peeling paint, and soft/rotting wood—especially on the right slope. Replace the rotted trim boards first before painting, as painting over soft wood will fail re-inspection.
- Estimated Time: 1 full weekend (1 day for carpentry, 1 day for prep and paint)
- Difficulty: Moderate DIY
What You'll Need
- Tools: Pry bar, hammer, miter saw or circular saw, drill/driver, putty knife, 5-in-1 painter's tool, wire brush, paintbrush/roller, sturdy ladder.
- Materials: Exterior-grade PVC trim boards (recommended so it never rots again) or primed cedar/pine 1x6 boards, galvanized or stainless steel trim screws, exterior wood filler, paintable silicone/acrylic caulk, exterior primer, 100% acrylic exterior paint.
Step-by-Step Instructions
- Pry off the damaged fascia. Carefully wedge a pry bar behind the rotted gable trim boards (seen in the third photo) and pull them away from the roof edge without tearing the drip edge or shingles.
- Measure and cut replacement boards. Use the old boards as templates to cut new PVC or primed wood trim to match the exact angles at the peak and eaves.
- Install the new trim. Fasten the new boards flush against the roof framing using exterior-grade screws, countersinking the heads slightly.
- Scrape and prime all surfaces. Use a 5-in-1 tool to scrape loose, flaking paint off the shed's siding and gable wall, then fill nail holes and caulk all seams.
- Apply two coats of exterior paint. Paint the entire shed—including the newly replaced fascia—on a dry day when temperatures stay above 40°F–50°F for proper curing.
2. Repair the Cracked House Foundation
Looking at your sixth photo (along the concrete walkway) and seventh photo (to the left of the front steps), there are hairline-to-narrow vertical cracks running through the painted parge coat/concrete foundation wall. While these look like typical settling cracks rather than severe structural shifting, NJM requires them sealed to prevent water intrusion and freeze-thaw damage.
- Estimated Time: 2–3 hours (plus drying time)
- Difficulty: Easy DIY
What You'll Need
- Tools: Wire brush, cold chisel and hammer (or angle grinder with masonry wheel), shop vac or stiff broom, caulk gun, margin trowel or putty knife.
- Materials: Polyurethane masonry crack sealant (for cracks under 1/4 inch) or hydraulic cement/vinyl concrete patch (for wider cracks), exterior masonry paint to color-match the gray foundation.
Step-by-Step Instructions
- Widen and clean the cracks. Use a cold chisel and hammer to lightly chip loose paint and crumbling mortar out of the vertical cracks shown along the driveway/walkway wall, creating a clean "V" groove.
- Brush out all dust. Scrub the groove thoroughly with a stiff wire brush and blow or vacuum away all loose debris so the patch bonds directly to solid masonry.
- Fill the crack. For narrow cracks, inject polyurethane masonry sealant deep into the joint and smooth it flush with a putty knife. For wider gaps, mist the concrete with water and press vinyl concrete patch firmly into the groove with a trowel.
- Paint over the repair. Once the sealant or patch cures completely, brush matching gray masonry paint over the repaired lines so the fix blends seamlessly for the inspector.
3. Remove Mold, Mildew, and Growth from the Roof
Your third photo shows heavy dark organic staining and moss/lichen buildup along the lower shed roof shingles, and your main house roof likely has similar shaded growth.
Warning: Never use a pressure washer on asphalt shingles—it strips away protective granules and voids warranties, which will cause an immediate insurance failure. Wet roofs are also dangerously slick; work from a ladder or use a ground-level sprayer if possible.
- Estimated Time: 2–4 hours (plus a few days for dead growth to rinse off)
- Difficulty: Easy to Moderate DIY
What You'll Need
- Tools: Pump garden sprayer, garden hose with standard spray nozzle, soft-bristle brush (optional for stubborn moss).
- Materials: Oxygen bleach roof cleaner (sodium percarbonate) or a commercial zinc/bleach-free roof wash (such as Wet & Forget or 30 Seconds Outdoor Cleaner).
Step-by-Step Instructions
- Wet surrounding plants. Thoroughly hose down the bushes, grass, and yard along the fence line (shown in your first photo) before applying any cleaner to protect them from runoff.
- Apply the roof cleaner. Mix your roof wash according to the label, load it into a pump sprayer, and saturate the stained shingles from the bottom edge upward.
- Let the solution dwell. Allow the cleaner to sit for 15–20 minutes (do not let it dry out in direct sun) so it breaks down the algae and moss roots.
- Rinse gently with a garden hose. Use low-pressure water from a standard hose to rinse away loosened debris; avoid scrubbing aggressively so you do not dislodge shingle granules.
Final Tips for Your 12/10/2026 Re-Inspection
- Document everything: Take clear "after" photos from the exact same angles as the inspection photos you shared here once each repair is finished.
- Notify NJM proactively: Call NJM's Personal Lines Department at 1-800-232-6600 a few days before 12/10/2026 to let them know the work is complete and ask if you can email your "after" photos directly to underwriting alongside the scheduled re-inspection. [1]
Would you like to tackle one of these repairs first—such as calculating paint/material quantities for the shed—or would you prefer help finding local handymen or roof cleaners near South Amboy to handle the ladder work before December 10?